EasyManuals Logo
Home>Barco>Projector>DP2K-E series

Barco DP2K-E series User Manual

Barco DP2K-E series
163 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #105 background imageLoading...
Page #105 background image
13. Lamp House
13.2 Removal of t he Lamp Module
WARNING: The Lamp Module is extremely hot during and directly after operation. Let the projector cool down
for at least 15 min utes before attempting to access or handle the L amp Mo dule.
WARNING: This procedure may only be carried out by t rained p rojectionists or qualied technical service
personn e l.
CAUTION: Due to its high internal pressu re, the lamp m ay explode in hot state if improperly han dled.
Necessary tools
7mm nut driver or at screw driver.
How to remove the Lamp Module from the projector?
1. Ensure the projector is switched off and cooled dow n.
2. Remove the rear cover of the projector. See "Removal of the rea r cover", p age 121.
3. Loosen the retaining s crew (1) of the fan door and open the door (2).
1
2
Image 13-2
4. Release the three retaining screws (3) of the Lamp Module. Use a 7m m nut driver or a a t s crew driver.
R5906693 DP2K-E SERIES 19/06/2015
101

Table of Contents

Other manuals for Barco DP2K-E series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Barco DP2K-E series and is the answer not in the manual?

Barco DP2K-E series Specifications

General IconGeneral
BrandBarco
ModelDP2K-E series
CategoryProjector
LanguageEnglish

Related product manuals