Barco DP2K-E series User Manual

5. Physical installation
5.3 Connecting a UPS to the projector electronics
WARNING: Only use UPS units whic h are suitable for the DP 2K-E series projector. See chap ter “Installation
requirements” for more information about the requirements of the UPS.
Necessary tools
3mm Allen wrench
How to connect the UPS
1. Remove the right side cover of the projector. See procedure "Rem oval of the right side cover", page 125.
2. Remove the rear cover. See "Rem oval of the rear cover", page 121.
3. Remove the 2 screws (1) of the SMPS co ver (2) and remove t he cover. Use a 3m m Allen wrench.
1
1
2
Image 5-6
4. Plug out the connector which is plugged into the AC socket (3). Plug the c onnector in the U PS socket (4).
3
4
Image 5-7
5. Install the S MP S cover and install the 2 screws. Use a 3mm Allen wrench.
6. Install the rear cover. See "Installation of the rear cover", page 13 4.
7. Install the UPS according to the instructions of the manufacturer a nd the local regulations.
8. Connect the power output cord from the UP S unit to the UPS inlet socket (5) of the projector.
28
R5906693 DP2K-E SERIES 19/06/2015

Barco DP2K-E series Specifications

General

Brand	Barco
Model	DP2K-E series
Category	Projector
Language	English