10. Starting up
10.1 Switching the DP2K-E series projector ON
How to switch on?
1. Ensure that the D P2 K-E ser ies projector is installed onto a stable platform.
2. Ensure the projector is correctly connected t o the mains power.
3. Ensure that the lamp and lamp house are c orrectly installed.
4. Ensure that the correct lens is installed for your application.
5. Check if a v ideo source is connec ted to the projector.
6. Press the Power Switch to switch the projector ON. As a result the projector starts up and the commu nicator touch panel starts
its initialization procedure.
Note: The p rojector always boo ts up in the same mode (E.g. Standby or Sleep) as it was switched off. T his procedure assumes
that the p rojector wa s s witched off in standby m ode (projector fully ope rational but lamp is off).
7. Wait until the status light of the projector lights up GREEN (not flashing).
8. Press the STANDBY button on the Local Keypad or use the Communica tor to activate the lamp.
9. Press the DOWSER button on the Local Key pad or use the Com municator to op en the dowser.
DOWSER
1
Image 10-1
How to awake the projector from Sleep mode?
1. Press the SLEEP button on the Local K eypad for three seconds or use the Communicator to put the projector in Standby mode.
As a result the p rojector s tarts booting and initializing all electronics. During the booting and initializing phase the backlight c olor
of the Sleep button is purple (transition phase). Once the pr ojector is fully awake the backlight color of the Sleep button is green.
Note: When the projector is in Sleep m ode only the bac klight of the Sleep button lights up red. The bac klight of all other buttons
of the Local Key pad remains off.
The backlight color of the Sleep button, Stand by button, Dowser button and Test Pattern button must all light
up green to project the image of the applied source.
CAUTION: See user ’s guide of the Communicator Touch Panel to operate and control the DP2K-E series pro-
jector.
When for any reason a restart of the projector is required, the content server should be restarted also.
76 R5906693 DP2K-E SERIES 19/06/2015
To Next Page
Loading...
Need help?
General
