16. Removal and installation of the projector covers
16. R EMOVAL AND INS TALLATION OF THE PROJECTOR
COVERS
About this chapter
Most installation, maintenance and service procedures demand removing one or more of the projector covers to gain access to the
parts to maintain or to service. To avoid redundancy, all procedures about cover removing or installing are grouped together in this
chapter. T he maintenance and s ervicing procedures also refer to this chapter if required. T he
procedures in this chapter describe,
with detailed s tep by step actions and illustration s, how to remove or install the pro jector cov ers. Note that the c overs may only be
removed by qualified service personnel.
WARNING: All p roced ures describ ed in this chapter may o nly be performed by TRAINED PROJECT IONISTS
or qualified SERVICE PERSONNEL.
WARNING: Always switch off the projector and unplug the p ow er cord before removing one of t he covers,
unless otherwise stated.
Overview
• Removal of the front cover
• Removal of the rear cover
• Removal of th e top cover
• R em oval of the left s ide cover
• Removal of the right side cover
• Removal of the top cover plate of the Light P rocessor com partment
• Removal of the side cover plate of the Light P rocessor compartmen t
• Installation of the side c over plate of the Light P rocessor compartmen t
• Installation of the top cover p late of the Light Processor com partment
• Installation of the right side c over
• Installation of the left side cover
• Installation of the top cover
• Installation of the rea r cover
• Installation of the f ront cover
R5906693 DP2K-E SERIES 19/06/2015
119
To Next Page
Loading...
Need help?
General
