Barco DP2K-E series User Manual

8. ICMP
8.11 Installing a HDD into the ICMP
This procedure assumes t hat the HDD slot of the ICMP is empty. If no t, s ee procedure "Remo ving a HDD form
the ICMP ", pag e 65.
CAUTION: Always us e a new empty spare part HDD from Barco to replace a malfunction HDD. Do not use a
HDD from another ICMP HDD set.
CAUTION: Always make sure that all HDDs in the ICMP HDD set have the same storage capa city. See label
on top of the HDD to know the storage capacity.
How to install a HDD ?
1. Ensure that the projector is switched off.
2. Prepare the HDD for insertion by mov ing the latch towards the left and push the unlock bu tton to op en the handle.
Image 8-15
3. Insert the HDD into the HDD slot. E nsure that the handle is sufficiently open so that the hook (reference 1) of the handle can
pass the front plate of the ICMP.
1
Image 8-16
4. Push the HDD completely and firmly inside its slot, close the handle, and move t he latch towards the right.
66
R5906693 DP2K-E SERIES 19/06/2015

Barco DP2K-E series Specifications

General

Brand	Barco
Model	DP2K-E series
Category	Projector
Language	English