7. Input & Communication
7.3 Projector Status
About the projector Status Light
The projector S tatus Light is located at the rear end of the pr ojector (Tail Light). The projector Status Light is real time indicator of
the projector condition.
Image 7-3
Status overview
Depending on the condition of the projector the status light may hav e 4 colors: G r een, Yellow, Red or Blue. Eac h color represen t a
different state:
Blinking Green Projector is booting up. (Fully booted up w hen Test Pattern button is white as well)
Green
Projector is runn ing normally.
Yellow Projector is running with warnings. Event ca n go on but a technical intervention will be necessary in
the near future to prevent a complete stop of the projector.
Red
Projector is in error s tate. Problem could prevent normal operation. Solve the problem before
continuing with the projector.
Blue Projector runs in notification state. Maintenance action r equired. Lamp run time is exc eeded.
New lamp must be installed.
Standby mode
In Standby mode the lamp of the proj
ector is switched OFF but all the electronics of the projector remain fully operational. The
projector is rea dy to ignite the lamp and p roject the image. The status light is not different between S tandby mode and Lamp ON
mode (fully operational).
Sleep mode
If the projecto r is in Sleep mode then the status light flashes e very ten seconds. The color o f the flash depends on the state of the
projector. In other words, the color of the flash w ill be green in normal state (no warnings, no errors, no notifications).
In Sleep mode the total power consumption of the projector is less than 15W. No fans are turning and the Lamp Power Supply (LPS )
is switched OFF com pletely. Only the following functionalities of the projector remains active:
• Cinema Controller
• Local Keypad
• R outer and external sw itch fully functional
• USB IN port type “B” (Virtual comport RS232)
• USB O UT port type “A” (To power handheld d evices [500mA MAX]. N o other functionality supported)
• GPIO port on the Cinema Controller
Pressing the Sleep button in Standby mode for 3 seconds puts the projector in Sleep mode. In case the projector is processing the
after cooling cycle then the projector goes in Sleep mod e after finishing the after cooling cycle.
Pressing the Sleep butto n in Sleep mode for 3 seconds will awake the projector. The status light will blink for a few seconds (booting
up all inactive boards) and then lights up continuously.
Enter or leave S leep mode can also be done via 2 dedicated projector com mand (USB /Ethernet), or via t wo predefined Macros (not
editable) with G PIO of the C
inema C on troller (not the GP IO of t he ICMP), o r via the Comm unicator.
R5906693 DP2K-E SERIES 19/06/2015
43
To Next Page
Loading...
Need help?
General
