11.68
Removing/installing conrod
•
Turn crankshaft to TDC position.
•
Lock the clutch housing with retaining fixture,
BMW No. 11 5 640.
•
Remove conrod.
L Note:
Conrods can also be removed/installed with the
crankshaft removed.
e Caution:
Do not accidentally confuse conrods or
bearing shells.
•
Install conrods.
Installed direction of conrods:
...................................................lettering facing up
e Caution:
Oil the bearings.
•
Screw the big end bolts in by hand, then tighten
with an angle-indicating wrench,
BMW No. 11 2 500.
e Caution:
Use big end bolts once only.
X Tightening torque:
Big end bolts oiled
Joint torque.................................................. 20 Nm
Wrench angle................................................... 80 °
11 2 500
11 5 640
TDC
RS110210
To Next Page
Loading...
Need help?
General
