11.81
Assembling engine
Installing conrod
•
Clamp crankshaft in a vise provided with
protective jaws.
•
Screw big end bolts (oiled) in by hand and tighten
with tightening angle indicator,
BMW No. 11 2 210.
e Caution:
Oil the bearings. Do not accidentally confuse
conrods or bearing shells. Always use new big
end bolts.
Installed direction of conrods:
...................................................lettering facing up
X Tightening torque:
Big end bolts (oiled)
Joint torque.................................................. 20 Nm
Wrench angle.................................................... 80°
11 2 210
RS110370
To Next Page
Loading...
Need help?
General
