00.35
Grease the centre stand [RS], side
stand and clutch cable nipple
(Inspection II, III, IV)
•
Clean and grease the nipple with a grease gun
until grease starts to emerge at the bearing point.
Lubricant:.................. e.g. Staburags NBU 30 PTM
Lubricant:................................ e.g. Shell Retinax A
[RS] Cleaning and greasing the
windshield adjusting shaft
(Inspection III)
•
Unscrew, clean and grease the shaft, then screw
it back in.
Lubricant:................................ e.g. Shell Retinax A
[RS] Grease front suspension strut at
its lower attachment lug
(version with plain bearing only)
(Inspection II, III)
Lubricant:....................................e.g. Never Seeze
X Tightening torque:
Spring strut to control arm ........................... 43 Nm
RS000330
RS330320
RS000360
To Next Page
Loading...
Need help?
General
