16.10
Removing and installing fuel filter
e Caution:
Note direction of fuel flow through filter (1).
Removing and installing fuel pump and
fuel level sensor
•
Unfasten electrical connections (2) at fuel
pump (3).
•
Unscrew hose clip (4).
•
Remove fuel pump.
•
Install in the reverse order of work.
•
Tighten non-reusable hose clips with special
pliers, BMW No. 13 1 500.
e Caution:
Use only an O-ring (5) in good condition. After
assembly, check fuel pump unit for leaks.
X Tightening torque:
Fuel pump assembly to tank .......................... 6 Nm
1
3
4
5
2
RS160030
To Next Page
Loading...
Need help?
General
