4 - 2
Adjustment Test mode
1. Starting in test mode
• With the front cover in place press and while turning the power on; the buzzer will sound four times,
and test mode will start.
2. Mode selection
• Press and select pattern number (mode).
3. Starting and stopping test mode
• Press (If not , use foot controller)
4. Test modes (used for adjustments)
Mode
Mode selection
Screen number
Z (zigzag)
operations
F (feed)
operations
Operating speed
3 point needle
drop
Press 2 times and
select pattern number.
Switches left base line / center
base line / right base line with
each stitch
*Pressing stops the base
line from changing.
0 mm
(none)
Any speed may be
selected using the
speed control key
Feed
adjustment
Press 5 times and
select pattern number.
100 stitches forward on the left base line
100 stitches reverse on the right baseline
Switches low / middle /
high speed with each
push of .
U1 U0
or
02
05
When the test mode will be changed the power off and the test mode will start again.
To Next Page
Loading...
Need help?
General
