Set Up a Roll Media Job
Introduction
Print jobs can be specified as either a roll job or a flatbed job in the ONYX workflow software. The
job type can be changed after the print job is transferred to the printer.
Purpose
The operator can choose the type of desired print job and also put a hold on it so it will not print
automatically.
Set up the Roll Job Option
When you set the page size for your print job, click on Type [Roll] to make it a roll media option
job.
[44] ONYX Page Size - Roll Option
Set a Hold on a Roll Job
Procedure
1.
To ensure that your roll media print job is held and not automatically printed, click on the box in
front of "Hold for printer operator" when you set the print options while creating an RMO media
in the ONYX workflow software
NOTE
If you don't set a hold, it is also possible to disable the Roll media print queue at the
printer. To do this click on the Roll icon in the command toolbar of the Print Job
module so that it become dim (greyed out). This will stop any roll media jobs from
automatically printing.
Set Up a Roll Media Job
Chapter 7 - Roll Media Option 111
To Next Page
Loading...
Need help?
General