Training Requirements
Introduction
The operator must receive training for safety issues, printer operation, and the appropriate ONYX
Thrive software prior to operating the printer.
Safety Training
Before operating the Arizona 1300 Series printer, make sure you have read and understood all of
Chapter 3 "Safety Guidelines".
Operator Training
For optimal safety and print quality, all printer operators must have received training by qualified
service personnel. training provides a general orientation to printer safety and operating
procedures. This User Guide is not a substitute for official training.
ONYX Workflow Training
Maximum performance from the printer requires a properly trained operator. trains the operator
in the use of the printer hardware and software at installation. However, this is not a substitute
for formal training.
Operators must be fully versed in the operation of ONYX Thrive Workflow software . For any
operator unfamiliar with their operation, training is required. Training courses are available;
contact your local representative for an ONYX-certified training program.
Training Requirements
64 Chapter 5 - Operate the Printer
To Next Page
Loading...
Need help?
General