Carrier i-Vu CCN Pro 4.2 User Manual

Monitor and control equipment
48 i-Vu CCN Pro 4.2
To create a group override CCN time schedule
When a group of controllers is assigned a matching Override Group number, an override from a single
controller in the group can cause all of the controllers in the Override group to be to overridden. The override
duration is set in i-Vu CCN Pro, even though i-Vu CCN Pro supports push-button override.
In order for a controller to initiate a remote override request:
• Set the actual duration of the override in i-Vu CCN Pro.
• Do not set the controller’s local override hours to 0.
• The controller's setting must be greater-than or equal-to the i-Vu CCN Pro override duration.
NOTES
• It is recommended that the local override value at the controller be set to its maximum possible setting.
• Equipment activation, when using PBOR’s, is normally instantaneous, but varying delays are possible.
• Do not press the button a second time, as this could cause the override to be cancelled.
In order to have a specific controller initiate a group override, the override duration in its local database must
not be zero.
1 On the navigation tree, select the equipment or area that you want to schedule for a group override.
2 Click the Schedules page, then CCN tab.
3 Enter the number of minutes in Override Time.
NOTE The override setting in the controller must not be set to 0.
4 Assign a number to Override group.
To apply a schedule to single equipment or to all equipment in an area
Schedules in i-Vu CCN Pro are typically based on zone occupancy.
1 On the navigation tree, select the equipment you want to schedule.
NOTE To schedule all equipment in a specified area, select the area you want.
2 Click the Schedules page > Configure tab.
3 Click Add.
4 Select a Priority. (Normal is low priority; Holiday is medium; Override is high.)
5 Select a Type. See table below.
6 Type a schedule name in the Description field.
7 Enter desired values in the fields below Description.
8 Change the default time segment (shown as a colored bar) for the schedule by doing one of the
following:
○ Click the segment, then type Start and End times in the fields above the segment.
○ Click and drag either end of the segment or the entire segment.
Optional: Click Show Advanced below the schedule bar to add one or more separate segments to the
schedule.

Carrier i-Vu CCN Pro 4.2 Specifications

General

Brand	Carrier
Model	i-Vu CCN Pro 4.2
Category	Control Systems
Language	English