Cisco 15216 EDFA2 User Manual

FINAL DRAFT - CISCO CONFIDENTIAL
8-7
Cisco ONS 15216 EDFA2 Operations Guide
78-16033-01
Chapter 8 Provisioning Using TL1
Set Alarm Thresholds
sidtidname 2002-07-11 11:16:10
M 125 COMPLD
"EQPT:MAXCTMP,,,65"
"EQPT:MAXCTMPHYST,,,5"
"EQPT:MINCTMP,,,10"
"EQPT:MINCTMPHYST,,,2"
;
To set the alarm thresholds, use the SET-TH-DWDM and SET-TH-EQPT commands (see
“SET-TH-DWDM” section on page 9-61 and “SET-TH-EQPT” section on page 9-63). Alarm threshold
attributes are described in Table 8-1.
Table 8-1 Alarm Threshold Attribute Definitions
Attribute
Variable
Definition Syntax
Maximum
Access Description
LOSTH Loss of signal
(input power)
threshold
Integer
(–3100 to
–1500)
Read-write Alarm notifies operations personnel if
the optical input signal of the
ONS 15216 EDFA2 drops below a
level that impacts proper operation of
optical network. Set this attribute at a
value that is appropriate for the
intended application so that the alarm
condition is meaningful. Consult with
the Cisco TAC to determine the
threshold value for your application.
As a guideline, Cisco recommends
setting the threshold value at 3 dBm
below the current input power level of
the amplifier. Valid entries are between
–3100 and –1500 dBm times 100. For
example, if the total input power of the
amplifier is –24 dBm and the loss of
input power threshold required is –27
dBm, the loss of input power alarm
threshold is –2700.

Cisco 15216 EDFA2 Specifications

General

Brand	Cisco
Model	15216 EDFA2
Category	Network Router
Language	English