FINAL DRAFT - CISCO CONFIDENTIAL
9-28
Cisco ONS 15216 EDFA2 Operations Guide
78-16033-01
Chapter 9 TL1 Commands
TL1 Commands and Autonomous Messages
9.7.20 REPT ALM EQPT
Command REPT ALM EQPT
Reports when a general alarm (not directly affecting optical signal or power bus) is logged or cleared
(derived from cerent15216EdfaAlarmState).
Syntax
<sid> <date> <time>
<almcde> <atag> REPT ALM EQPT
"<aid>:<ntfcncde>,<condtype>,<srveff>,<ocrdat>,<ocrtm>,,:<conddescr>"
;
Example 9-22 REPT ALM EQPT Message
Amp01 2001-06-18 14:48:44
* 141 REPT ALM EQPT
"EQPT:MN,LCRNT1,NSA,6-18,14-48-44,,:\"Excessive Pump1 Current\""
;
ntfncde Notification code (maps to cerent15216EdfaAlarmPriority).
Possible values are:
CR Critical alarm.
MJ Major alarm.
MN Minor alarm.
CL Cleared alarm.
NA No alarm.
ocrdat m-d Date (month-day) of the event occurrence (derived from
cerent15216EdfaDateAndTimeString).
ocrtm h-m-s Time (hour-minute-second) of the event occurrence (derived
from cerent15216EdfaDateAndTimeString).
sid string Source identifier uniquely identifies the source of a TL1
autonomous command.
time hh:mm:ss Time of origination of TL1 message.
Table 9-26 REPT ALM ENV Syntax Description (continued)
Parameter Syntax Description
To Next Page
Loading...
Need help?
General
