FINAL DRAFT - CISCO CONFIDENTIAL
9-60
Cisco ONS 15216 EDFA2 Operations Guide
78-16033-01
Chapter 9 TL1 Commands
TL1 Commands and Autonomous Messages
9.7.43 RTRV-USER-SECU
Command RTRV-USER-SECU
Retrieves the access level of an existing user from the system. Does not return the password.
Syntax
RTRV-USER-SECU:[<tid>]:<uid>:<ctag>;
<sid> <date> <time>
M <ctag> COMPLD
"<uid>,<al>"
;
Example 9-46 RTRV-USER-SECU Command and Response
Amp01:ONS15216 EDFA2> RTRV-USER-SECU:Amp01:jsmith:123;
Amp01 2002-05-13 17:23:16
M 123 COMPLD
"jsmith,RW"
;
9.7.44 SET-ATTR-SECUDFLT
Command SET-ATTR-SECUDFLT
Sets the timeout value of user sessions for users with a specific access level. If no communication occurs
for this time, the user session is closed by the ONS 15216 EDFA2 TL1 agent. Users affected by changes
to the timeout must log out and log in again for the change to take effect.
Syntax
SET-ATTR-
SECUDFL
T:[<ti
d>]::<ctag
>::AL=
<al>,TMOUT
=<time
out>
[,][,][,][,][,];Table 9-50 RTRV-USER-SECU Syntax Description
Parameter Syntax Description
sid string Source identifier uniquely identifies the source of a TL1
autonomous command.
al Access level of the user. See “Summary of Security Permissions
for TL1 Commands” section on page 9-6 for access level
permissions.
R Read only privileges.
RW Read and write privileges.
RWA Read, write, and administrative privileges.
uid string User identifier (user name) of the existing user. If no user
identifier is specified and the current user has RWA access
level, it will list all existing users and their security levels.
To Next Page
Loading...
Need help?
General
