FINAL DRAFT - CISCO CONFIDENTIAL
4-11
Cisco ONS 15216 EDFA2 Operations Guide
78-16033-01
Chapter 4 Provisioning Using ASH and SNMP
Add Users
Password =
****
New Password =
******
Confirm New Password =
******
Note The default user name for the administrator level is CISCO15 with no default password. To start a
session for this user name, press Enter.
4.10 Add Users
Use the user entry create command to add new users to the ONS 15216 EDFA2. The syntax is to enter
the command followed by the user name and then the access level (read, read_write, read_write_admin)
as shown in Example 4-10. The ONS 15216 EDFA2 responds with a request for the password.
Passwords must be an ASCII string of up to 10 characters, where at least 2 are non-alphabetic characters with
at least one special character. Special characters are +, #, and % (defined in Telcordia GR-831-CORE).
Example 4-10 Adding a New User
ash:hostname:ONS15216 EDFA2> user entry create janedoe read_write
New Password =
*********
Confirm New Password =
*********
4.11 Save Changes
To ensure that the provisioning changes are set, you must save your changes prior to terminating the
session. To save changes, use the snmp attribute set local cerent15216EdfaOpSaveConfig perform
command (Example 4-11).
Example 4-11 Saving Changes
ash:hostname:ONS15216 EDFA2> snmp attribute set local cerent15216EdfaOpSaveConfig perform
Most SNMP configuration attributes require the above save command before terminating the session
(does not apply to TL1 shell). The exceptions to this save requirement (the attributes that are
automatically saved) are shown below:
• cerent15216EdfaPowerBusMode
• cerent15216EdfaPowerBusDCVoltageMin
• cerent15216EdfaPowerBusDCVoltageMax
• cerent15216EdfaPumpCfgControlMode and the corresponding pump control value
• cerent15216EdfaConstGainOverallGain
• cerent15216EdfaVariableGainPreAttenuation
• SromIpMgmtGroup attributes:
–
cerent15216EdfaSromIpMgmtEnetAddress
To Next Page
Loading...
Need help?
General
