FINAL DRAFT - CISCO CONFIDENTIAL
9-41
Cisco ONS 15216 EDFA2 Operations Guide
78-16033-01
Chapter 9 TL1 Commands
TL1 Commands and Autonomous Messages
9.7.28 RTRV-COND-ALL
Command RTRV-COND-ALL
Generates a report on the condition (state) of all alarms (except environmental alarms). Note that the ccm
does not appear in the response for EQPT alarms.
Note The messages for Loss of Signal (LOS), Gain Out of Range (GAIN), and Loss of Output Power
(LPOUT) are prioritized (in the order just listed) so that only one message can be delivered at one time.
For example, if the ONS 15216 EDFA2 detects both a loss of input signal and a loss of output power at
the same time, it will deliver only the Loss of Signal (LOS) message to the user. This prioritized filtering
of alarms does not occur with the SNMP delivery of alarms of the ONS 15216 EDFA2.
Syntax
RTRV-COND-ALL:[<tid>]::<ctag>::[<condtype>][,,,];
<sid> <date> <time>
M <ctag> COMPLD
"<aid>,<ccm>:<ntfcncde>,<condtype>,<srveff>,<ocrdat>,<ocrtm>,,,<conddescr>"
;
Example 9-30 RTRV-COND-ALL Command and Response
Amp01:ONS15216 EDFA2> RTRV-COND-ALL:Amp01::229::LCRNT1;
Amp01 2002-06-20 14:30:00
M 229 COMPLD
"1,DWDM:MJ,LOS,SA,6-20,14-25-30,,,\"Loss Of Signal\""
"EQPT,EQPT:MN,LCRNT1,NSA,6-20,14-25-30,,,\"Excessive Pump1 Current\""
;
Table 9-35 RTRV-COND-ALL Syntax Description
Parameter Syntax Description
aid Possible values are:
1 Directly affecting the optical signal.
EQPT General parameters of the ONS 15216 EDFA2 (not directly
affecting optical signal or power bus).
conddescr Detailed text description of the event. The conddescr is 1 to 64
characters of ASCII text. See condtype below.
To Next Page
Loading...
Need help?
General
