PurposeCommand
Displays information about the IP address and receiving
port for the most-recently received IGMP query messages
in the VLAN.
(Optional) Enter detail to display the detailed IGMP querier
information in a VLAN.
(Optional) Enter vlan vlan-id to display information for a
single VLAN.
show ip igmp snooping querier [ detail | vlan
vlan-id]
Displays the snooping configuration information for all
VLANs on the device or for a specified VLAN.
(Optional) Enter vlan vlan-id to display information for a
single VLAN. The VLAN ID range is 1 to 1001 and 1006
to 4094.
show ip igmp snooping [vlan vlan-id [ detail
] ]
Displays wireless-related events.show ip igmp snooping wireless mgid
Displaying IGMP Filtering and Throttling Configuration
You can display IGMP profile characteristics, and you can display the IGMP profile and maximum group
configuration for all interfaces on the device or for a specified interface. You can also display the IGMP
throttling configuration for all interfaces on the device or for a specified interface.
Table 12: Commands for Displaying IGMP Filtering and Throttling Configuration
PurposeCommand
Displays the specified IGMP profile or all the
IGMP profiles defined on the device.
show ip igmp profile [profile number]
Displays the configuration of the specified
interface or the configuration of all interfaces on
the device, including (if configured) the
maximum number of IGMP groups to which an
interface can belong and the IGMP profile
applied to the interface.
show running-config [interface interface-id]
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
80 OL-29890-01
Configuring IGMP
Displaying IGMP Filtering and Throttling Configuration
To Next Page
Loading...
Need help?
General