CHAPTER 11
Configuring IP Multicast Routing
•
Finding Feature Information, page 251
•
Prerequisites for Configuring IP Multicast Routing, page 251
•
Restrictions for Configuring IP Multicast Routing, page 252
•
Information About IP Multicast Routing, page 252
•
How to Configure Basic IP Multicast Routing, page 256
•
Monitoring and Maintaining IP Multicast Routing, page 268
•
Configuration Examples for IP Multicast Routing, page 272
•
Where to Go Next for IP Multicast, page 272
•
Additional References, page 273
•
Feature History and Information for IP Multicast, page 274
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest feature
information and caveats, see the release notes for your platform and software release.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Prerequisites for Configuring IP Multicast Routing
The following are the prerequisites for configuring IP multicast routing:
•
To use the IP multicast routing feature on the device, the device or active device must be running the
IP Services feature set.
•
You must enable IP multicast routing and configure the PIM version and PIM mode on the device. After
performing these tasks, the device can then forward multicast packets and can populate its multicast
routing table.
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
OL-29890-01 251
To Next Page
Loading...
Need help?
General