Cisco Catalyst 3650 User Manual

PurposeCommand or Action
Example:
Device(config)# no ip igmp ssm-map dns
Disable DNS-based SSM mapping if you only want to rely
on static SSM mapping. By default, the ip igmp ssm-map
global configuration command enables DNS-based SSM
mapping.
Note
Configures static SSM mapping.
ip igmp ssm-map static access-list
source-address
Step 5
The ACL supplied for access-list defines the groups to be mapped
to the source IP address entered for the source-address.
Example:
Device(config)# ip igmp ssm-map static
You can configure additional static SSM mappings. If
additional SSM mappings are configured and the router
receives an IGMPv1 or IGMPv2 membership report for a
group in the SSM range, the device determines the source
addresses associated with the group by using each
configured ip igmp ssm-map static command. The device
associates up to 20 sources per group.
Note
11 172.16.8.11
—
Repeat Step 4 to configure additional static SSM
mappings, if required.
Step 6
Returns to privileged EXEC mode.end
Example:
Device(config)# end
Step 7
Verifies your entries.show running-config
Example:
Device# show running-config
Step 8
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Device# copy running-config
Step 9
startup-config
Related Topics
Configuring Static SSM Mapping (CLI), on page 240
Configuring Static SSM Mapping (CLI), on page 240
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
OL-29890-01 241
Configuring SSM
Configuring Source Specific Multicast Mapping

Cisco Catalyst 3650 Specifications

General

Brand	Cisco
Model	Catalyst 3650
Category	Switch
Language	English