Device(config)# end
This example shows how to statically configure a host on a port:
Device# configure terminal
Device(config)# ip igmp snooping vlan 105 static 224.2.4.12 interface gigabitethernet1/0/1
Device(config)# end
This example shows how to enable IGMP Immediate Leave on VLAN 130:
Device# configure terminal
Device(config)# ip igmp snooping vlan 130 immediate-leave
Device(config)# end
This example shows how to set the IGMP snooping querier source address to 10.0.0.64:
Device# configure terminal
Device(config)# ip igmp snooping querier 10.0.0.64
Device(config)# end
This example shows how to set the IGMP snooping querier maximum response time to 25 seconds:
Device# configure terminal
Device(config)# ip igmp snooping querier query-interval 25
Device(config)# end
This example shows how to set the IGMP snooping querier timeout to 60 seconds:
Device# configure terminal
Device(config)# ip igmp snooping querier timer expiry 60
Device(config)# end
This example shows how to set the IGMP snooping querier feature to Version 2:
Device# configure terminal
Device(config)# no ip igmp snooping querier version 2
Device(config)# end
Related Topics
Enabling or Disabling IGMP Snooping on a Device (CLI), on page 57
IGMP Snooping, on page 28
Examples: Configuring Filtering and Throttling
This example shows how to create IGMP profile 4 allowing access to the single IP multicast address and how
to verify the configuration. If the action was to deny (the default), it would not appear in the show ip igmp
profile output display.
Device(config)# ip igmp profile 4
Device(config-igmp-profile)# permit
Device(config-igmp-profile)# range 229.9.9.0
Device(config-igmp-profile)# end
Device# show ip igmp profile 4
IGMP Profile 4
permit
range 229.9.9.0 229.9.9.0
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
82 OL-29890-01
Configuring IGMP
Examples: Configuring Filtering and Throttling
To Next Page
Loading...
Need help?
General