Cisco Catalyst 3650 User Manual

DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Device> enable
•
Enter your password if prompted.
Enters the global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Specifies the interface to be configured, and enters interface configuration
mode.
interface interface-id
Example:
Device(config)# interface
Step 3
The specified interface must be one of the following:
• A routed port—A physical port that has been configured as a Layer 3
port by entering the no switchport interface configuration command.
gigabitethernet 1/0/1
You will also need to enable IP PIM sparse-dense-mode on the
interface, and join the interface as a statically connected member to
an IGMP static group. For a configuration example, see Example:
Interface Configuration as a Routed Port, on page 83
• An SVI—A VLAN interface created by using the interface vlan
vlan-id global configuration command. You will also need to enable
IP PIM sparse-dense-mode on the VLAN, join the VLAN as a statically
connected member to an IGMP static group, and then enable IGMP
snooping on the VLAN, the IGMP static group, and physical interface.
For a configuration example, see Example: Interface Configuration as
an SVI, on page 83
These interfaces must have IP addresses assigned to them.
Configures the frequency at which the device sends PIM router-query
messages.
ip pim query-interval seconds
Example:
Device(config-if)# ip pim
Step 4
The default is 30 seconds. The range is 1 to 65535.
query-interval 45
Returns to privileged EXEC mode.end
Example:
Device(config-if)# end
Step 5
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
154 OL-29890-01
Configuring PIM
Modifying the PIM Router-Query Message Interval (CLI)

Cisco Catalyst 3650 Specifications

General

Brand	Cisco
Model	Catalyst 3650
Category	Switch
Language	English