Cisco Firepower 2100 User Manual

Power on the Device, on page 105.Pre-Configuration
(Optional) Check the Software and Install a New Version, on page 106CLI
(Optional) Change Management Network Settings at the CLI, on page 107.CLI
Log Into the Device Manager, on page 109.Device Manager
Complete the Initial Configuration, on page 110.Device Manager
(Optional) Obtain feature licenses (Configure Licensing, on page 111).Cisco Commerce
Workspace
Generate a license token (Configure Licensing, on page 111).Smart Software
Manager
Register the device with the Smart Licensing Server (Configure Licensing, on
page 111).
Device Manager
Configure the Firewall in the Device Manager, on page 118.Device Manager
Review the Network Deployment and Default Configuration
You can manage the threat defense using the device manager from either the Management 1/1 interface or
the inside interface. The dedicated Management interface is a special interface with its own network settings.
The following figure shows the recommended network deployment. If you connect the outside interface
directly to a cable modem or DSL modem, we recommend that you put the modem into bridge mode so the
threat defense performs all routing and NAT for your inside networks. If you need to configure PPPoE for
the outside interface to connect to your ISP, you can do so after you complete initial setup in device manager.
Cisco Firepower 2100 Getting Started Guide
101
Threat Defense Deployment with the Device Manager
Review the Network Deployment and Default Configuration

Cisco Firepower 2100 Specifications

General

Brand	Cisco
Model	Firepower 2100
Category	Gateway
Language	English