Cisco Firepower 2100 User Manual

Step 4 Click Edit ( ) for the interface that you want to use for outside.
The General tab appears.
Figure 57: General Tab
You already pre-configured this interface for manager access, so the interface will already be named, enabled,
and addressed. You should not alter any of these basic settings because doing so will disrupt the management
center management connection. You must still configure the Security Zone on this screen for through traffic
policies.
a) From the Security Zone drop-down list, choose an existing outside security zone or add a new one by
clicking New.
For example, add a zone called outside_zone.
b) Click OK.
Step 5 Click Save.
Configure the DHCP Server
Enable the DHCP server if you want clients to use DHCP to obtain IP addresses from the threat defense.
Cisco Firepower 2100 Getting Started Guide
82
Threat Defense Deployment with a Remote Management Center
Configure the DHCP Server

Cisco Firepower 2100 Specifications

General

Brand	Cisco
Model	Firepower 2100
Category	Gateway
Language	English