Cisco Firepower 2100 User Manual

If you do not have a console connection, wait approximately 3 minutes to ensure the system has shut down.
Step 7 You can now turn off the power switch and unplug the power to physically remove power from the chassis
if necessary.
Power Off the Device at the CLI
You can use the FXOS CLI to safely shut down the system and power off the device. You access the CLI by
connecting to the console port; see Access the Threat Defense and FXOS CLI, on page 42.
Procedure
Step 1 In the FXOS CLI, connect to local-mgmt:
firepower # connect local-mgmt
Step 2 Issue the shutdown command:
firepower(local-mgmt) # shutdown
Example:
firepower(local-mgmt)# shutdown
This command will shutdown the system. Continue?
Please enter 'YES' or 'NO': yes
INIT: Stopping Cisco Threat Defense......ok
Step 3 Monitor the system prompts as the firewall shuts down. You will see the following prompt:
System is stopped.
It is safe to power off now.
Do you want to reboot instead? [y/N]
Step 4 You can now turn off the power switch and unplug the power to physically remove power from the chassis
if necessary.
What's Next?
To continue configuring your threat defense, see the documents available for your software version at Navigating
the Cisco Secure Firewall Threat Defense Documentation.
For information related to using the management center, see the Cisco Secure Firewall Management Center
Device Configuration Guide.
Cisco Firepower 2100 Getting Started Guide
44
Threat Defense Deployment with the Management Center
Power Off the Device at the CLI

Cisco Firepower 2100 Specifications

General

Brand	Cisco
Model	Firepower 2100
Category	Gateway
Language	English