Cisco Firepower 2100 User Manual

Add the Default Route
The default route normally points to the upstream router reachable from the outside interface. If you use DHCP
for the outside interface, your device might have already received a default route. If you need to manually
add the route, complete this procedure. If you received a default route from the DHCP server, it will show in
the IPv4 Routes or IPv6 Routes table on the Devices > Device Management > Routing > Static Route
page.
Procedure
Step 1 Choose Devices > Device Management, and click Edit ( ) for the device.
Step 2 Choose Routing > Static Route.
Figure 19: Static Route
Step 3 Click Add Route, and set the following:
Cisco Firepower 2100 Getting Started Guide
34
Threat Defense Deployment with the Management Center
Add the Default Route

Cisco Firepower 2100 Specifications

General

Brand	Cisco
Model	Firepower 2100
Category	Gateway
Language	English