Your password was updated successfully.
[...]
firepower#
Step 2 At the FXOS CLI, show the running version.
scope ssa
show app-instance
Example:
Firepower# scope ssa
Firepower /ssa # show app-instance
Application Name Slot ID Admin State Operational State Running Version Startup
Version Cluster Oper State
-------------------- ---------- --------------- -------------------- ---------------
--------------- ------------------
ftd 1 Enabled Online 7.6.0.65 7.6.0.65
Not Applicable
Step 3 If you want to install a new version, perform these steps.
a) If you need to set a static IP address for the Management interface, see Perform Initial Configuration
Using the CLI, on page 144. By default, the Management interface uses DHCP.
You will need to download the new image from a server accessible from the Management interface.
b) Perform the reimage procedure in the FXOS troubleshooting guide.
After the firewall reboots, you connect to the FXOS CLI again.
c) At the FXOS CLI, you are prompted to set the admin password again.
For low-touch provisioning, when you onboard the device, for the Password Reset area, be sure to choose
No... because you already set the password.
d) Shut down the device. See Power Off the Device at the CLI, on page 172.
Log Into CDO
For details on creating a CDO tenant and logging in, see the CDO doucmentation:
https://docs.defenseorchestrator.com.
Deploy the Firewall With Low-Touch Provisioning
After you receive the threat defense from central headquarters, you only need to cable and power on the
firewall so that it has internet access from the outside interface. The central administrator can then complete
the configuration.
Cisco Firepower 2100 Getting Started Guide
133
Threat Defense Deployment with CDO
Log Into CDO
To Next Page
Loading...
Need help?
General