You can log in with any username if you added users in FXOS. If you configure remote management, SSH
to the ASA data interface IP address on port 3022 (the default port).
Step 2 Connect to the ASA CLI.
connect asa
To return to the FXOS CLI, enter Ctrl+a, d.
Example:
firepower-2110# connect asa
Attaching to Diagnostic CLI ... Press 'Ctrl+a then d' to detach.
Type help or '?' for a list of available commands.
ciscoasa>
Step 3 If you SSH to the ASA (after you configure SSH access in the ASA), connect to the FXOS CLI.
connect fxos
You are prompted to authenticate for FXOS; use the default username: admin and password: Admin123. To
return to the ASA CLI, enter exit or type Ctrl-Shift-6, x.
Example:
ciscoasa# connect fxos
Connecting to fxos.
Connected to fxos. Escape character sequence is 'CTRL-^X'.
FXOS 2.2(2.32) kp2110
firepower-2110 login: admin
Password: Admin123
Last login: Sat Jan 23 16:20:16 UTC 2017 on pts/1
Successful login attempts for user 'admin' : 4
Cisco Firepower Extensible Operating System (FX-OS) Software
[…]
firepower-2110#
firepower-2110# exit
Remote card closed command session. Press any key to continue.
Connection with fxos terminated.
Type help or '?' for a list of available commands.
ciscoasa#
What's Next
• To continue configuring your ASA, see the documents available for your software version at Navigating
the Cisco ASA Series Documentation.
• To configure FXOS chassis settings, see the FXOS configuration guide.
• For troubleshooting, see the FXOS troubleshooting guide.
Cisco Firepower 2100 Getting Started Guide
227
ASA Deployment with ASDM
What's Next
To Next Page
Loading...
Need help?
General