Cisco Firepower 2100 User Manual

Firepower 2100 Appliance Mode Default Configuration
The Firepower 2100 runs in Appliance mode by default.
For pre-9.13(1) versions, Platform mode was the default and only option. If you upgrade from Platform mode,
Platform mode is maintained.
Note
The default factory configuration for the Firepower 2100 in Appliance mode configures the following:
• inside→outside traffic flow—Ethernet 1/1 (outside), Ethernet 1/2 (inside)
• outside IP address from DHCP, inside IP address—192.168.1.1
• management IP address from DHCP—Management 1/1 (management)
• DHCP server on inside interface
• Default routes from outside DHCP, management DHCP
• ASDM access—Management and inside hosts allowed. Inside hosts are limited to the 192.168.1.0/24
network.
• NAT—Interface PAT for all traffic from inside to outside.
• DNS servers—OpenDNS servers are pre-configured.
The configuration consists of the following commands:
Cisco Firepower 2100 Getting Started Guide
180
ASA Deployment with ASDM
Firepower 2100 Appliance Mode Default Configuration

Cisco Firepower 2100 Specifications

General

Brand	Cisco
Model	Firepower 2100
Category	Gateway
Language	English