xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1021
Chapter 100
Tech Support
Commands
upload tech_support_toTFTP <ipaddr> <path_filename 64>
100-1 show tech_support
Description
This command is used to display technical support information. It is especially useful for technical
support personnel that need to view the overall device operation information.
Format
show tech_support
Parameters
None.
Restrictions
Only Administrator and Operator-level users can issue this command.
Note: The switch may become inaccessible when dumping the technical support data.
Note: The management session may time out if dumping technical support data takes
longer than the configured session timeout period. It is strongly recommended to
set the serial port timeout to never to disable the auto disconnection of the console
session.
Example
To display technical support information:
DGS-3620-28SC:admin#show tech_support
Command: show tech_support
#-----------------------------------------------------------------------------
# DGS-3620-28SC Gigabit Ethernet Switch
# Technical Support Information
#
# Firmware: Build 2.00.015
# Copyright(C) 2012 D-Link Corporation. All rights reserved.
To Next Page
Loading...
Need help?
General