D-Link DGS-3620-52P User Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
223
15-12 config cfm ports
Description
This command is used to enable or disable the CFM function on a per-port basis. By default, the
CFM function is disabled on all ports. If the CFM is disabled on a port:
 MIPs are never created on that port.
 MEPs can still be created on that port, and the configuration can be saved.
 MEPs created on that port can never generate or process CFM PDUs. If the user issues a
Loopback or Link trace test on those MEPs, it will prompt the user to inform them that the
CFM function is disabled on that port
Format
config cfm ports <portlist> state [enable | disable]
Parameters
<portlist> - Specify the logical port list.
state - Specify the CFM function status.
enable - Specify to enable the CFM function.
disable - Specify to disable the CFM function.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
To enable the CFM function on ports 2 to 5:
DGS-3620-28SC:admin#config cfm ports 2-5 state enable
Command: config cfm ports 2-5 state enable
Success.
DGS-3620-28SC:admin#
15-13 show cfm ports
Description
This command is used to display the CFM state of specified ports.
Format
show cfm ports <portlist>
Parameters
<portlist> - Specify the logical port list.

D-Link DGS-3620-52P Specifications

General

Brand	D-Link
Model	DGS-3620-52P
Category	Switch
Language	English