xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
213
<uint 1-4294967295>] mepid <int 1-8191> {period [1sec | 1min] | level <int 0-7> | state
[enable | disable]}
config cfm lock md [<string 22> | md_index <uint 1-4294967295>] ma [<string 22> | ma_index
<uint 1-4294967295>] mepid <int 1-8191> {period [1sec | 1min] | level <int 0-7> | state
[enable | disable]}
15-1 create cfm md
Description
This command is used to create a CFM maintenance domain.
Format
create cfm md <string 22> {md_index <uint 1-4294967295>} level <int 0-7>
Parameters
<string 22> - Enter the maintenance domain name used here. This name can be up to 22
characters long.
md_index - Specifies the maintenance domain index used.
<uint 1-4294967295> - Enter the maintenace domain index value used here. This value must
be between 1 and 4294967295.
level - Specify the maintenance domain level.
<int 0-7> - Specify the maintenance domain level from 0 to 7.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
To create a CFM maintenance domain called “op_domain” and assign a maintenance domain level
of “2”:
DGS-3620-28SC:admin#create cfm md op_domain level 2
Command: create cfm md op_domain level 2
Success.
DGS-3620-28SC:admin#
15-2 config cfm md
Description
This command is used to configure the parameters of a maintenance domain. The creation of
MIPs on an MA is useful to trace the link, MIP by MIP. It also allows the user to perform a loopback
from an MEP to an MIP.
To Next Page
Loading...
