xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
329
Format
debug routefilter show [prefix_list | access_list | route_map]
Parameters
prefix_list - Specifies to display prefix list debug information.
access_list - Specifies to display access list debug information.
route_map - Specifies to display route map debug information.
Restrictions
Only Administrator-level users can issue this command.
Example
To display route filter information in kernel:
DGS-3620-28SC:admin# debug routefilter show route_map
Command: debug routefilter show route_map
route_map : map1
--------------------------
sequence : 10 (Permit)
Match clauses:
prefix_list : pr_list1
Set clauses:
metric : 80
Success.
DGS-3620-28SC:admin#
20-75 debug show status
Description
Show the debug handler state and the specified module’s debug status.
If the input module list is empty, the states of all registered modules which support debug module
will be shown.
Format
debug show status {module <module_list>}
Parameters
module – (Optional) Specifies the module list.
<module_list> - Enter the module list here.
Restrictions
Only Administrator-level users can issue this command.
To Next Page
Loading...
Need help?
General