xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
797
Chapter 72
Password Recovery
Commands
disable password_recovery
72-1 enable password_recovery
Description
This command is used to enable the password recovery mode.
Note: The configuration does not take effect until saved.
Format
enable password_recovery
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example
To enable the password recovery mode:
DGS-3620-28SC:admin# enable password_recovery
Command: enable password_recovery
Success.
DGS-3620-28SC:admin#
72-2 disable password_recovery
Description
This command is used to disable the password recovery mode.
Note: The configuration does not take effect until saved.
To Next Page
Loading...
Need help?
General