xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
580
Chapter 49
LACP Configuration
Commands
config lacp_port <portlist> mode [active | passive]
show lacp_port {<portlist>}
49-1 config lacp_port
Description
This command is used to configure per-port LACP mode.
Format
config lacp_port <portlist> mode [active | passive]
Parameters
<portlist> - Specify a range of ports to be configured.
mode – Specify the port mode.
active - Specify the mode as active.
passive - Specify the mode as passive.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure port LACP mode for ports 1 to 3:
DGS-3620-28SC:admin#config lacp_port 1-3 mode active
Command: config lacp_port 1-3 mode active
Success.
DGS-3620-28SC:admin#
49-2 show lacp_port
Description
This command is used to display per-port LACP mode.
Format
show lacp_port {
<portlist>}
To Next Page
Loading...
Need help?
General