xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
961
89-18 show snmp host
Description
This command is used to display the recipient for which the traps are targeted.
Format
show snmp host {<ipaddr>}
Parameters
<ipaddr> - (Optional) Specify the IP address of the recipient for which the traps are targeted.
Note: If no parameter is specified, all SNMP hosts will be displayed.
Restrictions
None.
Example
To display the receipient for which the traps are targeted:
DGS-3620-28SC:admin# show snmp host
Command: show snmp host
SNMP Host Table
Host IP Address SNMP Version Community Name / SNMPv3 User Name
--------------- --------------- ---------------------------------
10.48.76.100 V3 noauthnopriv initial
10.51.17.1 V2c public
Total Entries : 2
DGS-3620-28SC:admin#
89-19 show snmp v6host
Description
This command is used to display the recipient for which the traps are targeted.
Format
show snmp v6host {<ipv6addr>}
Parameters
<ipv6addr> - (Optional) Specify the v6host IP address.
To Next Page
Loading...
Need help?
General