xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
625
DGS-3620-28SC:admin#config loopdetect recover_timer 0 interval 20 mode vlan-
based
Command: config loopdetect recover_timer 0 interval 20 mode vlan-based
Success.
DGS-3620-28SC:admin#
54-2 config loopdetect ports
Description
This command is used to set up the loop-back detection function for the ports on the switch.
Format
config loopdetect ports [
<portlist> | all] state
[enab
le | disable]
Parameters
<portlist> - Specify a range of ports to be configured.
all - To set all ports in the system, use the all parameter.
state – Specify the status.
enable - Enable loop-detect for the ports specified in the port list.
disable - Disable loop-detect for the ports specified in the port list. The default is disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To set up loop-back detection:
DGS-3620-28SC:admin#config loopdetect ports 1-5 state enable
Command: config loopdetect ports 1-5 state enable
Success.
DGS-3620-28SC:admin#
54-3 enable loopdetect
Description
This command is used to allow the loop detection function to be globally enabled on the switch.
The default value is disabled.
Format
enable loopdetect
To Next Page
Loading...
Need help?
General