xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
279
20-14 debug stp state
Description
This command is used to enable or disable the STP debug state.
Format
debug stp state [enable | disable]
Parameters
state - Specifies the STP debug state.
enable - Enable the STP debug state.
disable - Disable the STP debug state.
Restrictions
Only Administrator level users can issue this command.
Example
To configure the STP debug state to enable, and then disable the STP debug state:
DGS-3620-28SC:admin# debug stp state enable
Command: debug stp state enable
Success.
DGS-3620-28SC:admin# debug stp state disable
Command: debug stp state disable
Success.
DGS-3620-28SC:admin#
20-15 debug ospf
Description
This command is used to enable or disable OSPF debug flags.
Format
debug ospf [neighbor_state_change | interface_state_change {dr_bdr_selection} | lsa {all |
originating | installing | receiving | flooding} (1) | packet {all | receiving | sending} (1) |
retransmission | spf {all | intra | inter | extern} (1) | timer | virtual_link | route | redistribution]
state [enable | disable]
To Next Page
Loading...
Need help?
General