D-Link DGS-3620-52P - Debug Config State

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
272
Example
To set the switch to not need a reboot when a fatal error occurs:
DGS-3620-28SC:admin# debug config error_reboot disable
Command: debug config error_reboot disable
Success.
DGS-3620-28SC:admin#
20-7 debug config state
Description
Use the command to set the state of the debug.
Format
debug config state [enable | disable]
Parameters
enable - Enable the debug state.
disable - Disable the debug state.
Restrictions
Only Administrator level users can issue this command.
Example
To set the debug state to disabled:
DGS-3620-28SC:admin# debug config state disable
Command: debug config state disable
Success.
DGS-3620-28SC:admin#
20-8 debug show error_reboot state
Description
Use the command to show the error reboot status.
Format
debug show error_reboot state