D-Link DGS-3620-52P User Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
269
->809E1DEC
->809D7E6C
->80A038CC
->80A033B0
->80A0297C
To clear the error log:
DGS-3620-28SC:admin# debug error_log clear
Command: debug error_log clear
Success.
DGS-3620-28SC:admin#
To upload the error log to TFTP server:
DGS-3620-28SC:admin# debug error_log upload_toTFTP 10.0.0.90 debug-log.txt
Command: debug error_log upload_toTFTP 10.0.0.90 debug-log.txt
Connecting to server................... Done.
Upload configuration................... Done.
DGS-3620-28SC:admin#
20-4 debug buffer
Description
Use this command to show the debug buffer’s state, or dump, clear, or upload the debug buffer to
a TFTP server.
Note: When selecting to output to the debug buffer and there are debug messages being
outputted, the system memory pool will be used as the debug buffer. The functions which will use
the system memory pool resource may fail to execute command such as download and upload
firmware, or save configuration. If you want to execute these commands successfully, please use
the command “debug buffer clear” to release the system’s memory pool resources manually first.
Format
debug buffer [utilization | dump | clear | upload_toTFTP <ipaddr> <path_filename 64>]
Parameters
utilization - Display the debug buffer’s state.
dump - Display the debug message in the debug buffer.
clear - Clear the debug buffer.
upload_toTFTP - Upload the debug buffer to a TFTP server specified by IP address.
<ipaddr> - Specifies the IPv4 address of the TFTP server.
<path_filename 64> - The pathname specifies the DOS pathname on the TFTP server. It can
be a relative pathname or an absolute pathname. This value can be up to 64 characters

D-Link DGS-3620-52P Specifications

General

Brand	D-Link
Model	DGS-3620-52P
Category	Switch
Language	English