xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
270
Restrictions
Only Administrator level users can issue this command.
Example
To show the debug buffer’s state:
DGS-3620-28SC:admin# debug buffer utilization
Command: debug buffer utilization
Allocate from : System memory
Total size : 2 MB
Utilization rate : 30%
DGS-3620-28SC:admin#
To clear the debug buffer:
DGS-3620-28SC:admin# debug buffer clear
Command: debug buffer clear
Success.
DGS-3620-28SC:admin#
To upload the messages stored in debug buffer to TFTP server:
DGS-3620-28SC:admin# debug buffer upload_toTFTP 10.0.0.90 debugcontent.txt
Command: debug buffer upload_toTFTP 10.0.0.90 debugcontent.txt
Connecting to server................... Done.
Upload configuration................... Done.
DGS-3620-28SC:admin#
20-5 debug output
Description
Use the command to set a specified module’s debug message output to debug buffer or local
console. If the user uses the command in a Telnet session, the error message also is output to the
local console.
Note: When selecting to output to the debug buffer and there are debug messages being
outputted, the system memory pool will be used as the debug buffer. The functions which will use
the system memory pool resource may fail to execute command such as download and upload
firmware, or save configuration. If you want to execute these commands successfully, please use
the command “debug buffer clear” to release the system’s memory pool resources manually first.
To Next Page
Loading...
Need help?
General