xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
55
Format
config accounting service [network | shell | system] state [enable | disable]
Parameters
network - Specify the accounting service for 802.1X and WAC/JWAC port access control. By
default, the service is disabled.
shell - Specify the accounting service for shell events. When a user logins or logouts of the
switch (via the console, Telnet, or SSH) and when timeout occurs, accounting information will
be collected and sent to the RADIUS server. By default, the service is disabled.
system - Specify the accounting service for system events: reset and reboot. By default, the
service is disabled.
state - Specify the state of the accounting service.
enable - Enable the specified accounting service.
disable - Disable the specified accounting service.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the state of the RADIUS accounting service shell to enable:
DGS-3620-28SC:admin# config accounting service shell state enable
Command: config accounting service shell state enable
Success
DGS-3620-28SC:admin#
3-30 show accounting service
Description
This command is used to display RADIUS accounting service information.
Format
show accounting service
Parameters
None.
Restrictions
None.
Example
To display accounting service information:
To Next Page
Loading...
Need help?
General