Parameter 0-83 Additional Non-working Days
Table 53: Parameter 0-83 Additional Non-working Days
0-83 Additional Non-working Days
Default value: Size related
Parameter type: Range, 0 - 0, Array [15]
Change during operation: True
Array with 15 elements [0]–[14] shown below the parameter number in the display. Press [OK] and step between elements with [▵]
and [â–¿]. Defines dates for additional working days that would normally be non-working days according to parameter 0-81 Working
Days.
Parameter 0-84 Time for Fieldbus
Table 54: Parameter 0-84 Time for Fieldbus
Parameter type: Range, 0 - 4294967295, Array [2]
Change during operation: True
Shows the time for fieldbus.
Parameter 0-85 Summer Time Start for Fieldbus
Table 55: Parameter 0-85 Summer Time Start for Fieldbus
0-85 Summer Time Start for Fieldbus
Parameter type: Range, 0 - 4294967295, Array [2]
Change during operation: True
Shows the summer time start for fieldbus.
Parameter 0-86 Summer Time End for Fieldbus
Table 56: Parameter 0-86 Summer Time End for Fieldbus
0-86 Summer Time End for Fieldbus
Parameter type: Range, 0 - 4294967295, Array [2]
Change during operation: True
Shows the summer time end for fieldbus.
Parameter 0-89 Date and Time Readout
Table 57: Parameter 0-89 Date and Time Readout
0-89 Date and Time Readout
Parameter type: Range, 0 - 25
Change during operation: True
Shows the current date and time. The date and time is updated continuously. The clock does not begin counting until a setting
different from default has been made in parameter 0-70 Date and Time.
5.2 Parameter Group 1-** Load and Motor
5.2.1 1-0* General Settings
Define whether the drive operates in speed mode or torque mode, and whether the internal PID control should be active or not.
AU275636650261en-000101 / 130R033462 | Danfoss A/S © 2022.12
Parameter Descriptions
VLT AutomationDrive FC 301/302
Programming Guide
To Next Page
Loading...
Need help?
General