BASIC OPERATIONS
40 77144 Issue 8 August 2009
200ml Base
Note: New printers are shipped with a protective tube over the septum, ensure this is
removed prior to fitting the ink bottle.
When the ink bottle is exhausted, printing will continue for a short while because
of the small reserve of ink in the header tank. When the ink supply to the header
tank runs low, the replenishment indicator on the base unit will flash. If it is empty,
replace as follows:
(1) Open the base door by pushing the catch
toward the door and twisting 90º
anticlockwise. Unscrew to remove the used
ink bottle. Ensure the use by date on the new
ink bottle has not expired and unscrew the
protective cap from the bottle non-leak top.
(2) Gently push the top of the bottle into the housing
containing the steel puncture probe.
(3) When the ink bottle is located, apply a small
downward pressure and twist the bottle in a
clockwise direction until it tightens.
(4) Close the base unit door.
Note: Discard any used or damaged ink bottles in
accordance with local waste disposal legislation. Do
not attempt to reuse used or damaged ink bottles.
To Next Page
Loading...
Need help?
General
