FORMATTING MESSAGES
88 77144 Issue 8 August 2009
FORMATTING MESSAGES
CREATING A MESSAGE
A “message” is a line or lines of text, bar codes and graphics (“logos”) that are
printed to produce information on the substrate.
Messages can be saved into the memory and will remain even when the power is
removed. These messages can be edited and updated at any time or erased if no
longer required.
Zero characters can be toggled to print as 0 or ∅ (with a slash). Press upshift and
0 to display the following message (depending on which 0 state the printer is
currently set):
Press upshift and 0 to toggle again.
ZERO WITHOUT SLASH
PRESS ANY KEY
TO CONTINUE
ZERO WITH SLASH
PRESS ANY KEY
TO CONTINUE
To Next Page
Loading...
Need help?
General
