PROGRAMMING THE PRINTER
77144 Issue 8 August 2009 79
ERASING THE CONTROL UNIT MEMORY
To erase the control unit memory, follow the steps below:
CAUTION:
Do not
use this function unless the whole control unit memory
needs to be wiped. All saved messages, logos and saved settings will
be wiped and replaced with the default settings.
(1) Enter the clear all menu, for extra
security, a screen will prompt for the re-entry
of the user password (numeric only for
C6000MF). Once the password has been
entered, press the enter key to confirm.
(2) Press enter to confirm or escape to
return to the main menu.
After the memory wipe has commenced the
screen will indicate that the system is
initialising. After a few seconds the memory
will be reset to the initial factory settings.
(3) The screen will indicate that the test message
is ready to print. For new C6000MF
printers this will be the default message.
ALL MESSAGES
WILL BE LOST
PRESS TO CONFIRM
OR ESC TO RESUME
PRINTING TEST
NORMAL PRINT
INK STATUS OK
To Next Page
Loading...
Need help?
General
