EasyManua.ls Logo

Doosan PU158TI - Routine Inspection and Maintenance; Intake Air; Exhaust System

Doosan PU158TI
165 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Maintenance of Major Components
- 136 -
5.4.7. Routine inspection and maintenance
Since the state of turbocharger depends largely on the state of engine maintenance, to perform the
specified up keep thoroughly is needed.
1) Intake air
System in the intake air system, care must be taken to the air cleaner. In case of oil passing type air
cleaner, if the oil level is lower than the specified value, the cleaning efficiency get worse, if higher,
the sucked oil pollutes a case. Particularly, for if the rotor were polluted, the balance adjusted
precisely would be deviated to cause a vibration that may cause the stuck or abnormal wear by
loading large force to the bearing, the perfect air cleaner must always be used. In case of dry type
filter, according to the indication of a dust indicator, cleaning must be done to make the intake air
resistance as small as possible.
2) Exhaust system
In exhaust system, a care must be taken to the gas leak and the stuck prevention If exhaust gas
leaks from the exhaust pipe and turbocharger etc., for the super charging effect will be lowered, the
installed states of various parts must be paid with careful attention. Since the parts that reach to high
temperature during operation such as the turbine room use the anti- heat nuts, a care must be paid
not to mix with the general nuts and at the same time, bolt stuck preventing paint should be coated
on the nut for the designated places.
3) Fuel system
If the full load stopper that restricts the maximum fuel injection quantity of fuel injection pump and the
maximum speed stopper that restricts the maximum speed are adjusted without the pump tester, the
turbocharger may overrun to be damaged. Also, if the atomizing state of fuel injection nozzle
becomes worse or the injection timing gets wrong, for the raised temperature of exhaust gas will
influence badly to the turbocharger, the nozzle testing must be done.
4) Lubricating system
In the lubricating system, a care must be paid to the oil quality and oil element replacement cycle.
For the oil deterioration of turbocharger equipped engine, needless to speak of engine assembly
itself, influences badly to the turbocharger too, the specified engine oil (15W40, CE class) should
used.

Table of Contents