Safety Regulations & Engine Specifications
- 2 -
2) During maintenance and care
z
Always carry out maintenance work when the engine is switched off. If the engine has to be
maintained while it Is running, e.g. changing the elements of change-over filters, remember that
there is a risk of scalding. Do not get too close to rotating parts.
z
Change the oil when the engine is warm from operation.
CAUTION :
There is a rise of burns and scalding. Do not touch oil drain plug or oil filters with
bare hands.
z
Take into account the amount of oil in the sump. Use a vessel of sufficient size to ensure that the
oil will not overflow.
z
Open the coolant circuit only when the engine has cooled down. If opening while the engine is still
warm is unavoidable, comply with the instructions in the chapter “Maintenance and Care”.
z
Neither tighten up nor open pipes and hoses (lube oil circuit, coolant circuit and any additional
hydraulic oil circuit) during the operation. The fluids which flow out can cause injury.
z
Fuel is inflammable. Do not smoke or use naked lights in its vicinity. The tank must be filled only
when the engine is switched off.
z
When using compressed air, e.g. for cleaning the radiator, wear goggles.
z
Keep service products (anti-freeze) only in containers which can not be confused with drinks
containers.
z
Comply with the manufacturer’s instructions when handling batteries.
CAUTION :
Accumulator acid is toxic and caustic. Battery gases are explosive.
3) When carrying out checking, setting and repair work
z
Checking, setting and repair work must be carried out by authorized personnel only.
z
Use only tools which are in satisfactory condition. Worn open-end wrench slip. which could lead to
Injury.
z
When the engine is hanging on a crane, no-one must be allowed to stand or pass under it. Keep
lifting gear in good condition.
z
When working on parts which contain asbestos, comply with the notes at the end of this chapter.
z
When checking injectors do not put your hands under the jet of fuel. Do not inhale atomized fuel.
z
When working on the electrical system disconnect the battery earth cable first. Connect it up
again last in prevent short circuits.
To Next Page
Loading...
Need help?
General
